LCcsm0001 Jay Long, CCL - Port Townsend, WA - USA
June 07, 2019 at 16:13:20
In Reply to Re: WTB Bianchi # 104 key machine|
Posted by Tom Gillingham, CML, CPS, CIL - Nashville, TN - USA -
June 06, 2019 at 19:28:56
This has me wondering if there may be a slight "tilting" of the key inside of plugs that don't have tight tolerances.|
By that I mean clockwise / counter-clockwise, and not bow to tip.
The bottom pins would then contact the key near the edges of the cuts instead of exactly in the center.
If that were the case - the exact contact point could vary, depending on how quickly the turning action is applied and how sloppy the "fit" is, of the key in the keyway.
Just a thought...